Valor Inspire 600FS Installer And Owner Manual page 27

INSTALLER GUIDE
Upper cable locations
masonry drill for the wall plugs supplied. The
holes should be equidistant each side of the
centre line of the fireplace to ensure that the
appliance finishes centrally in the opening
when tension is applied to the cables.
Lower cable retention
3. Insert a wall plug into each hole. Use the
wall plugs supplied with this appliance - Never use plastic plugs instead of the
wood wall plugs supplied. Screw the eyebolts into the plugs. Make sure that the
bolts are secure.
4. Place the convection box fully back into the fireplace opening so that it is sealed
against the fireplace front surround.
Always screw the base into position before
applying tension to the cables. This will ensure a
tight seal between the top of the convection box
and wall.
5. The convection box has two slots at each side of
the flue outlet. Loop one end of each cable and pass
the loop into the slots as shown. Give the cables a
pull so that they grip.
6. Place the convection box unit close to the
fireplace but allow sufficient access into the fireplace
opening so that the cables can be threaded through
the eyebolts and returned through the back of the
Side view of Cable route
convection box. If a concealed connection is being
© Page 27
GDC Group Ltd. AUG 2016