Daikin FTXA20A Service Manual page 141

Repair procedures
To remove the swing flap motor gearcase assembly
FTXA20~50A(W)(S)(T) + FTXA20~50B(B)(S)(T) + RXA42+50A +
RXA20~35A(9) + RXA42+50B
Split Stylish R32
ESIE18-03D – 2021.05
Pins
7-8
7-9
7-10
8-9
8-10
9-10
Swing flap motor resistance
measurements are correct?
Yes
No
INFORMATION
To replace the motor, the complete gearcase assembly MUST be replaced.
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Remove the main swing flap from the indoor unit (by clicking it out).
2 Remove the secondary swing flap from the indoor unit (by clicking it out).
3 Remove the right side fan guard from the indoor unit (by clicking it out).
b
c
a Fan guard
b Rocker arm
c Swing raster
4 Remove the 3 screws from the swing flap motor gear case assembly. Do NOT
yet remove the assembly from the indoor unit.
Measured resistance (Ω)
465~535
Action
Return to the troubleshooting of the
specific error and continue with the
next procedure.
Replace the swing flap motor, see
"Repair procedures" [
"2.14 Plate
a
2 Components
|
4
141].
4
work" [ 120].
Service manual
141