Daikin FTXA20A Service Manual page 127

To remove the front panel
FTXA20~50A(W)(S)(T) + FTXA20~50B(B)(S)(T) + RXA42+50A +
RXA20~35A(9) + RXA42+50B
Split Stylish R32
ESIE18-03D – 2021.05
Note: Press and hold
4 Turn the power supply off.
5 Pull down both locks on the back of the front panel.
6 Open the front panel until the support fits into the fixing tab.
a Lock (1 on each side)
b Backside of the front panel
c Fixing tab
d Support
INFORMATION
If you CANNOT find the user interface or you use another optional controller. Pull the
front panel carefully up by hand as shown in the following figure.
INFORMATION
Remove the front panel only in case it MUST be replaced.
1 Open the front panel. See
2 Open the panel locks located on the back side of the panel (1 on each side).
a
a Panel lock
3 Push the right arm lightly to the right to disconnect the shaft from the shaft
slot on the right side.
again for at least 2 seconds to close the front panel.
b
a
"To open the front
2 Components
|
c
d
4
panel" [ 126].
a
Service manual
127