Table of Contents
Advertisement
AI Measurement
AI Measurement
Press the [
] buttons to display results from
each measurement.
Example: If 35 waveforms are measured:
34/35 35/35 AVG 1/35 2/35
The pulse wave number is displayed below the
waveform (in the center lower-left part of the
screen). [Fig. 8]
8
Press
the
START
measuring. At this time, the message "Start
measurement with the same ID?" will be
displayed. Select "Yes" or "No".
Select the START button [Yes] to begin
measurement with the current ID.
Select the STOP button [No] to erase the ID
and return to the default screen. Enter the ID
for the next patient.
Select the F1 key [CANCEL] to return to the
previous screen and change the measurement
mode. [Fig. 9]
If during measurement the waveform becomes
irregular or it is determined that the
pressurization value is incorrect, an error
message will appear on screen (E72 - 86). In
this case, measure again. Refer to the error list
on pages 78 - 79. An error message window
appearing in the middle of the screen can be
closed by pressing any button.
Pulse wave number
button
to
continue
40
[Fig. 8]
[Fig. 9]
Advertisement
Table of Contents
