Porter-Cable OMNIJIG 55160 Instruction Manual page 7

®
STANDARD OMINJIG PARTS
The OMNIJIG ® comes standard with various
bits, template guides, stops and a template.
®
The 24" OMNIJIG comes standard with a
variable finger template that is used to cut through
dovetails and half-blind dovetails (variable and
single-pass).
®
The 16" OMNIJIG comes standard with a
single-pass half-blind/sliding tapered dovetail
template that is used to cut single-pass half-blind
joints and the sliding tapered dovetail dado.
Standard equipment for each is shown here.
77240: 24" OMNIJIG SYSTEM
1. Jig base
2. 24" variable finger template
3. Instructional DVD
4. Left and right stops (labeled A4, B1, C1)
5. Dovetail bit (labeled D4)
6. Straight bit (labeled S2)
7. Square screwdriver
8. Wrench
9. Template guides, G0 (85/128"), G1 (5/8"),
G2 (39/64"), G3 (19/32"), G4 (37/64"), G5
(9/16") and G6 (15/32")
10. Lock nuts (for all template guides)
11. Router bit depth pod
12. Stabilizer bar
13. Two rubber O-rings
14. Dovetail setup guide (not shown)
55160: 16" OMNIJIG SYSTEM
1. Jig base
2. 16" single-pass half-blind/sliding tapered
dovetail template
3. Instructional DVD
4. Left and right stops (labeled C2)
5. Dovetail bit (labeled D4)
6. Square screwdriver
7. Wrench
8. Template guides, labeled G2 (39/64"), G3
(19/32"), G4 (37/64") and G5 (9/16")
9. Lock nut (for all template guides)
10. Stabilizer bar
11. Router bit depth pod
12. Two rubber O-rings
77240
11
4
12
4
55160
10
1
2
11
4
1
2
4
7
8
5
6
3
9
10
13
6
7
5
8
3
9
12