Porter-Cable OMNIJIG 55160 Instruction Manual page 29

4. After the bulk of the material has been
removed, the D6 bit is used with the
G1 template guide to complete the cuts
on the tails.
5. The pins are then cut using the S2
straight bit and the G5 template guide,
as shown on the dovetail setup guide.
NOTE: You might find it desirable to make
multiple passes of the S2 straight bit
with increasing depths of cut in or-
der to reduce the vibration on the S2
straight bit.
CUTTING TAILBOARD
1. Insert proper stops (E) Fig. D5
according to the Dovetail Setup Guide.
2. Remove stabilizer bar (F).
3. Make sure variable-spaced finger
template is mounted onto the rods
with the red "A Tails" label (G) facing
up to the left side.
4. Mount a scrap board in the horizontal
position, as shown at (H). Be sure this
board is the same thickness as the
pinboard.
NOTE: Place a board of similar thickness
horizontally at the right side of the jig
for support.
5. Mount the tailboard in the vertical
position (I) with the "outside surface"
facing the jig and flush with the bottom
of the template.
NOTE: "Outside surface" refers to the outer
side of the box or drawer the board will
be used on.
E
H
I
G
Fig. D5
F