Table of Contents
Advertisement
6.
Pull horizontal scrap (H) Fig. D6 forward against the
back of the vertical tailboard (I), as shown in Fig. D6.
7.
Be sure both boards are lined up flush against the left
offset guide (J).
8.
Position the fingers using the supplied square
screwdriver. An 1/8" gap is recommended between
the vertical board and the fingers as shown at (K) and
(L) in Fig. D7. This will help maintain proper spacing
at the corners.
NOTE: Before making cut, put at least one finger set (M)
Fig. D7 1-2 inches away from the right edge of the
vertical board for router stability.
9.
Make sure template (N) Fig. D8 is flat on the horizontal
boards and tighten template lock knobs, one of which
is shown at (O).
10. Replace stabilizer bar (F) Fig. D8.
11. Select and install proper dovetail bit and template
guide in your router according to the Dovetail Setup
Guide.
12. Set router bit depth at the gauge (P) Fig. D8 located at
the left side of the template.
O
P
H
J
I
Fig. D6
N
Fig. D8
M
K
L
Fig. D7
F
Hide quick links:
Advertisement
Table of Contents
