Table of Contents
Advertisement
SETUP AND CUTTING FOR
BOTH TEMPLATES
1.
Remove stabilizer bar (F) Fig. F7
and template (M).
2.
Set black edge guide (H) to right
and silver edge guide (I) to the
left.
3.
Insert proper stops (J).
4.
Put pinboard (drawer front) (K)
in the horizontal position with
"outside surface" facing the jig.
Don't worry about position at this
point, but don't let the board go
beyond the front edge of the base
(L).
5.
Mount template (M).
NOTE: Mount fixed finger templates as
shown in Fig. F7.
6.
Make sure similar thickness scrap
(S) is in the other side and clamp
the template down.
NOTE: For the variable-spaced finger
template, be sure the scrap is
supporting the end of the finger
set (T) Fig. F8.
J
S
K
I
L
Fig. F8
H
F
M
Fig. F7
T
Hide quick links:
Advertisement
Table of Contents
