Table of Contents
Advertisement
SETTING UP AND MAKING THE CUT
When cutting single-pass half-blind joints, the OMNIJIG
system provides on-board instruction labels to help
guide you through the process. Use this list to find the
proper label for your setup:
24" variable finger template: Instructions on
stabilizer bar
16" fixed finger template: Instructions on stabilizer
bar.
24" fixed finger template: Instructions on
template
ADDITIONAL SETUP NEEDED FOR THE
VARIABLE FINGER TEMPLATES
If you have a variable finger template, follow these three
steps to prepare the template before continuing:
placed up and to the left.
slide all fingers to the left.
at the end of bar (Q). Slide bar all the way through
holes in fingers and replace set screw (P). Then
tighten finger screws (O). Be sure set screw (P)
and (R) Fig. F6 are in place so bar does not slide
out.
N
®
O
P
O
Fig. F4
P
Fig. F5
R
Fig. F6
Q
Hide quick links:
Advertisement
Table of Contents
