Porter-Cable OMNIJIG 55160 Instruction Manual page 51

SETTING UP AND CUTTING THE JOINT
(VARIABLE FINGER TEMPLATES)
NOTE: Before proceeding, consult the variable-spaced half-
blind instructions (or the labels on the unit) for proper set-up.
CUTTING THE PINBOARD
1. Clamp the rabbeted pin board (drawer front) (H) Fig.
G4 in the horizontal position with the "outside surface"
against the jig's base. Make sure board is flush with the
edge guide (I).
2. Mount rabbeted setup block (E) Fig. G5, vertically with
the rabbeted edge facing the horizontal workpiece.
3. Bring the pinboard (H) forward so it just touches the
setup block (E).
4. Remove setup block (E).
H
I
H
Fig. G5
Fig. G4
E