5-3-4. Converting 3G-SDI SQD to 12G-SDI (MFR-2SDOGB)
MFR-6000
routing
Open the Gearbox Settings page in the WebGUI and select signal formats under
1.
From and To as shown below for a Gearbox in the MFR-2SDOGB card block. (This
example sets Gearbox 1 on the Slot 15 card.)
2.
Open the Destination Assignment page in the WebGUI and assign the physical
channels (SDI 56 Link A to D) to logical channels (DST1-4).
3.
Use a remote control unit or the Crosspoint page in the WebGUI to perform the crosspoint
switches.
*
When converting 4K signals from 3G Quad-Link to 12G Single-Link, 3G-SDI Black or
12G-SDI Link 1 are selectable for remaining 3 SDI output signals.
5-3-5. Payload ID
Adding Payload ID information to Output Signals.
Select Payload ID information source for output signals.
Insert:
Data created for output signals.
Through:
Data embedded to input signals.
MFR-2SDOGB
Quad Link
Gearbox 1
3G-SDI
(SQD)
48
12G-SDI