Starting Up; Operation For Tig Mode - Linde BOC RAPTOR Operating Manual

1. TIG/DC (without pulse)
3. TIG/DC (with pulse)
IMPORTANT
Before you begin a welding operation,
please press the torch switch for a few
seconds until all the air in the gas tube
is removed.
WARNING
It is dangerous to connect or disconnect
the gas hose or connector whilst welding.
2. TIG/AC (without pulse)
4. TIG/AC (with pulse)

6.2 Starting up

Switch on the machine using the Power Switch. The
panel will display the previous settings that were
saved in the last shutdown.

6.3 Operation for TIG mode

Set welding mode
Press the welding menu button
panel to choose the welding mode. The machine
enters TIG mode when TIG symbol
the display.
There are four TIG modes: TIG/DC (without pulse),
TIG/AC (without pulse), TIG/DC (with pulse) and
TIG/AC (with pulse). (Figures 1-4).
on the front
is shown on
17