Table of Contents
Advertisement
6.0 Installation & Operation TIG welding
Installation for TIG setup
3 4
1
6.1
Installation for TIG welding
1 Plug the work return lead into output socket ,
and tighten firmly.
2 Connect work return clamp to the work piece.
3 Plug the 8-pin plug of TIG torch into the welding
machine control socket.
4 Plug gas and electric connector of TIG torch to
welding machine's gas and electric socket, and
tighten firmly.
5 Connect gas regulator to gas cylinder.
6 Connect one end of gas hose to gas outlet of
gas regulator. Fasten the hose clamp. Connect
the other end to gas inlet on rear panel of
welding machine.
7 Connect with single phase 240V power supply.
Turn power switch ON (switch is located on the
back of the welding machine).
16
6
2
5
7
15A
Advertisement
Table of Contents
