Installing With Red Hat Linux; Installing With Suse Linux; Installing With Netware - Adaptec 29320LPE Installation And User Manual

Installing with Red Hat Linux

To install the SCSI card driver while installing Red Hat Linux:
Note:
For the most up-to-date information on Linux support, visit www.adaptec.com.
1
Insert the first Red Hat installation CD.
2
Restart the system.
3
When the Red Hat Welcome screen appears, type
4
When prompted, insert the driver disk, then select OK.
5
Follow the prompts to set up the environment you want.
6
If you are installing other third-party devices, install them now. Otherwise, select Done.
7
Continue with the Linux installation, according to the Red Hat instructions.

Installing with SUSE Linux

To install the SCSI card driver while installing SUSE Linux:
Note:
For the most up-to-date information on Linux support, visit www.adaptec.com.
1
Insert the first SUSE Installation CD.
2
Restart your system.
3
When the SUSE installation selection screen appears, choose the type of installation you
want, then ...
For SLES 9.0: Press the F6 key to indicate the use of a driver disk. (If F6 is not shown on the
screen, you may have an older version of SUSE; press the Alt key instead.)
For SLES 10.0: Press the F5 key and select Yes to indicate the use of a driver disk.
4
When prompted, insert the driver disk, then press any key to continue.
5
Follow the prompts to set up the environment you want.
6
If you are installing other third-party devices, install them now. Otherwise, select Back.
7
Complete the Linux installation, following the instructions included with your operating
system.

Installing with NetWare

To install the SCSI card driver while installing NetWare:
1
Restart your system, then install NetWare. (For instructions, refer to your NetWare
documentation).
2
To be able to load additional drivers later, select Manual install mode during the first part
of the installation.
3
When the Device Drivers screen displays, check the storage adapters list, then select
Modify to add another driver.
4
Select Storage Adapters, then press Enter.
Chapter 6: Installing the Driver and an Operating System
linux dd
●
at the Boot: prompt.
29