Fence Scale Calibration - Woodstock Shop Fox W1888 Owner's Manual

Model W1888 (For Machines Mfd. Since 10/20)
Fence.Scale.Calibration
The fence scale indicator window, shown in Figure 119,
can be calibrated with the fence scale if you notice that
your cuts do not accurately match what is shown on the
fence scale.
The indicator adjusts by loosening the two mounting
screws and sliding it in the desired direction.
Tools.Needed.
Hex Wrench 3mm ...............................................1
Scrap Piece of Wood ............................................1
Tape Measure ....................................................1
To calibrate fence scale indicator windows, do these
steps:
1. Position and lock fence at 13", as indicated by scale,
then cut your scrap piece of wood.
2. Reposition and lock fence at 12", as indicated by
scale.
3. Flip your scrap piece of wood over, placing side that
was cut in Step 1 against fence, and cut your scrap
piece of wood.
4. Measure width of freshly cut workpiece with tape
measure. Workpiece width should be exactly 12".
If it is not, then adjust indicator window to match
width of workpiece.
Qty
Figure 119. Fence indicator window.
-75-
Screws
Indicator Window