Service; General; Blade Tilt Stops - Woodstock Shop Fox W1888 Owner's Manual

General

This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
techsupport@woodstockint.com.
Blade.Tilt.Stops
The table saw features stop collars that stop the blade
exactly at 45° and 90° when tilting it with the handwheel.
The stops have been set at the factory and should require
no adjustments, unless you notice that your cuts are not
accurate.
Note: The tilt scale reads "0" when the blade is 90° to the
table.
Tools.Needed.
90° Square .......................................................1
45° Square .......................................................1
Hex Wrench 2.5mm .............................................1
Hex Wrench 3mm ...............................................1
Setting.90°.Stop.Collar
1. DISCONNECT MACHINE FROM POWER!
2. Raise blade as high as it will go, then tilt it toward
0° until it stops and cannot be tilted any more.
3. Place 90° square against table and blade so it
contacts blade evenly from bottom to top, as shown
in Figure.101. Make sure blade tooth does not
obstruct placement of square.
— If blade is 90° to table, then adjustments do not
need to be made. Make sure tilt indicator arrow
shown in Figure 102 points to 0° mark on scale.
Adjust position by loosening button head screw,
moving indicator with your fingers, then tightening
screw.
— If blade is not 90° to table, you will need to
adjust 90° stop collar. Proceed to next step.
Model W1888 (For Machines Mfd. Since 10/20)

SERVICE

MAKE. SURE. that. your. machine. is.
unplugged. during. all. service. proce-
dures!. If. this. warning. is. ignored,. seri-
ous.personal.injury.may.occur.
Qty
Table
-66-
Blade
Figure.101..Checking blade at 90°.
Indicator
Figure 102. Tilt indicator arrow.
90° Square