Woodstock Shop Fox W1888 Owner's Manual page 38

Model W1888 (For Machines Mfd. Since 10/20)
Laminate.Blade.Features.(Figure.42):
• Best for cutting plywood or veneer
• 40-80 teeth
• Triple chip tooth profile
• Very shallow gullet
Thin.Kerf.Blade: A blade with thinner kerf than a
standard blade. Since the spreader/riving knife included
with this table saw is sized for standard blades, thin kerf
blades cannot be used on this saw unless they meet the
Blade.Requirements specified in this manual; otherwise,
they will increase the risk of kickback.
Dado.Blades
Stacked.Dado.Blade.(see.Figure.43): Multiple blades are
stacked together to control the cutting width. Stacked
dado blades are more expensive than wobble blades, but
typically produce higher quality results.
Wobble.Dado.Blade: A single blade mounted at a slight
angle on an arbor hub. The blade angle is adjustable on
the hub, and the width of the dado cut is controlled by
the angle setting of the blade.
Figure.42. Example of a laminate blade.
Figure.43. Stacked dado blade.
-35-
Triple
Chip
Blade