Operations; General - Woodstock Shop Fox W1888 Owner's Manual

Model W1888 (For Machines Mfd. Since 10/20)

General

This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
The overview below provides the novice machine operator
with a basic understanding of how the machine is used
during operation, so the machine controls/components
discussed later in this manual are easier to understand.
Due to its generic nature, this overview is NOT intended
to be an instructional guide.
To.complete.a.typical.operation,.the.operator.does.the.
following:
1. Examines workpiece to make sure it is suitable for
cutting.
2. Adjusts blade tilt, if necessary, to correct angle for
desired cut.
3. Adjusts blade height no more than
thickness of workpiece.
4. Adjusts fence to desired width of cut, then locks it
in place.
5. Checks outfeed side of machine for proper support
and to make sure workpiece can safely pass all the
way through blade without interference.
6. Puts on safety glasses, respirator, and hearing
protection, and locates push sticks/blocks if needed.
7. Starts saw.
8. Feeds workpiece all the way through blade while
maintaining firm pressure on workpiece against table
and fence, and keeping hands and fingers out of
blade path and away from blade.
9. Stops machine immediately after cut is complete.

OPERATIONS

⁄ " higher than
1
4
-31-
To. reduce. your. risk. of. serious. injury.
or. damage. to. the. machine,. read. this.
entire.manual.BEFORE.using.machine.
Eye. injuries,. respiratory. problems,. or.
hearing.loss.can.occur.while.operating.
this. tool.. Wear. personal. protective.
equipment. to. reduce. your. risk. from.
these.hazards.
If you are an inexperienced operator,
we strongly recommend that you read
books or trade articles, or seek training
from an experienced operator of this
type of machinery before performing
unfamiliar operations. Above.all,.safety.
must.come.first!