Push Blocks - Woodstock Shop Fox W1888 Owner's Manual

Model W1888 (For Machines Mfd. Since 10/20)
Push.Blocks
When used correctly, a push block reduces
the risk of injury by keeping hands away from
the blade while cutting. In the event of an
accident, a push block often takes the damage
that would have otherwise happened to hands
or fingers.
Using.a.Push.Block
A push block can be used in place of or in
addition to a push stick for feeding workpieces
into the blade. Due to their design, push blocks
allow the operator to apply firm downward
pressure on the workpiece that could not
otherwise be achieved with a push stick.
The push block design on this page can be used
in two different ways (see inset Figure 87.
below). Typically, the bottom of the push block
is used until the end of the workpiece reaches
the blade.
Making.a.Push.Block
Use this template to make your own push block.
Figure 87. Side view of a push block in use.
Notch for use
as a push stick
1 ⁄ " Grid
2
Figure 89. Template for a shop-made push block (shown at 50% of full size).
The notched end of the push block is then
used to push the workpiece the rest of the way
through the cut, keeping the operator's hands at
a safe distance from the blade. A push stick is
often used at the same time in the other hand
to support the workpiece during the cut (see
Using a Push Stick on previous page).
Handle for
firm grip
CAUTION: Only use hardwood, sturdy plywood, or
high-density plastic. Do not use softwood that
may break under pressure or metal that can break
teeth from the blade!
Lip for pushing workpiece
9"−10" Minimum Length
-59-
Push Stick
Prohibition
Zone
Push Stick
Supporting
Blade
Path
Feeding
Figure 88. Using a push block and push stick to
make a rip cut.
Make push block with
1 ⁄ "— 3 ⁄ " thick material
2 4
Push
Block
CAUTION: Bottom
of handle must be
at least 4" above
bottom of push
block to keep
hand away from
blade.
4"
1 ⁄ "— 1 ⁄ "
4 2