Woodstock Shop Fox W1888 Owner's Manual page 55

To build an auxiliary fence, do these steps:
1. Cut auxiliary fence board to size. If you are using
hardwood, cut board oversize, then joint and plane
board to correct size to make sure board is square
and flat.
2. Unthread (3) knobs and (3) flat washers securing
fence face to fence tube shown in Figure 74, then
remove fence.
3. Place auxiliary fence board against fence tube.
Place a thin metal shim (such as a ruler) between
table and bottom of auxiliary fence board to ensure
adequate clearance between fence board and table.
Clamp in position.
4. Mark location of three mounting holes on auxiliary
fence and remove auxiliary fence board from fence
tube.
5. Using
⁄ " drill bit, drill mounting holes in auxiliary
7
32
fence board. Countersink holes
of flat head cap screws sits slightly beneath face of
auxiliary fence board.
6. Insert (3) flat head cap screws through holes in
auxiliary fence board (see Figure 73.on Page.51)
and secure with knobs and flat washers removed
earlier. The end result should be similar to
Figure 75.
Model W1888 (For Machines Mfd. Since 10/20)
⁄ " deep so head
1
16
-52-
Knob
Flat Washer
(1 of 3
Figure 74. Location of knobs and flat
washers securing fence to fence tube.
Figure 75. Example auxiliary fence
Assembled Auxiliary Fence
attached to included fence.