Woodstock Shop Fox W1888 Owner's Manual page 27

9. Attach front rail to table with (2) M10-1.5 x 25 hex
bolts, (2) 10mm flat washers, and (2) 10mm lock
washers, as shown in Figure.21. Finger tighten
fasteners for now.
10.. Attach front rail to extension wings with (2) M10-1.5
x 35 hex bolts, (4) 10mm flat washers, (2) 10mm
lock washers, and (2) M10-1.5 hex nuts, as shown in
Figure.22. Finger tighten fasteners for now.
11.. Make sure top of rail is parallel with table top, then
tighten fasteners installed in Steps.9. – 10.
12. Install front rail tube to front rail with (5)
x ⁄ " hex bolts, 6mm flat washers, and 6mm lock
5
8
washers, as shown in Figure.23. Finger-tighten
fasteners for now.
13. While standing at front of table, pull rail tube
toward you as far as possible, then tighten fasteners
installed in Step.12. This will help make sure there
is enough room for fence to slide.
Model W1888 (For Machines Mfd. Since 10/20)
x 2
Figure.21. Front rail attached to table.
Figure.22. Front rail attached to extension
⁄ "-20
1
4
Figure.23. Front rail tube attached to
-24-
Front
Rail
x 2
wings.
x 5
front rail.