Woodstock Shop Fox W1888 Owner's Manual page 57

8. Plug in table saw, turn it ON, and use a push stick or
push block to feed workpiece through blade, using a
slow and steady feed rate.
Note: We recommend making a series of light cuts
that get progressively deeper, to reduce the chance
of stalling the motor.
9. Flip workpiece end for end, keeping same side
against fence, and run workpiece through blade
again.
10. Repeat Steps.7–9 until blade is close to half the
height of board to be resawn. The ideal completed
resaw cut will leave an
resawing is complete, as shown in Figure.77.
Leaving an ⁄ " connection will reduce risk of
1
8
kickback.
11. Turn OFF table saw, then separate parts of
workpiece and hand plane remaining ridge to remove
it.
12. When finished resawing, remove resaw barrier and
auxiliary fence, then re-install blade guard/spreader
or riving knife and standard table insert.
⁄ " connection when
1
8
-54-
Model W1888 (For Machines Mfd. Since 10/20)
The. danger. of. kickback. increases.
relative.to.the.depth.of.a.cut..Reduce.
risk. of. kickback. by. making. multiple.
passes.to.achieve.the.desired.depth.of.
cut.. Failure. to. follow. these. warnings.
could.result.in.serious.personal.injury.
Always.use.push.sticks.or.push.paddles.
to. increase. safety. and. control. during.
operations. which. require. that. blade.
guard. and. spreader. must. be. removed.
from.saw..ALWAYS.replace.blade.guard.
after.resawing.is.complete.
Workpiece
Resaw
Barrier
/ " Connection
1
8
Figure.77. Ideal completed resaw
operation.
Auxiliary
Fence
Fence