Woodstock Shop Fox W1888 Owner's Manual page 54

Model W1888 (For Machines Mfd. Since 10/20)
To.build.a.resaw.barrier,.do.these.steps:
1. Cut your wood pieces to specified size. If you are
using hardwood, cut pieces oversize, then joint and
plane them to correct size to make sure they are
square and flat.
2.. Pre-drill and countersink four holes approximately
⁄ " from bottom of 5
3
8
3. Glue end of 3" board, then clamp boards at a 90°
angle with larger board in vertical position, as shown
in Figure.72, and fasten them together with wood
screws.
Making.Auxiliary.Fence
An auxiliary fence is necessary if you are resawing a
workpiece that is taller than it is wide. The fence should
be no less than ⁄ " a than the board to be resawn.
1
2
The fence should be similar to the one in Figure.73.
when installed.
Tools.Needed:.
Clamps ............................................................2
Drill ...............................................................1
Drill Bit ⁄ " .....................................................1
7
32
Countersink Drill Bit ............................................1
Hex Wrench 5mm ...............................................1
Ruler ..............................................................1
Components Needed:
Flat Head Cap Screws M6-1 x (Auxiliary Fence Width +
Fence Tube Width) ..............................................3
Wood* ⁄ " x 4" x Length of Fence ............................1
3
4
*Only use furniture-grade plywood, kiln-dried hardwood,
or HDPE plastic to prevent warping. Ensure the flat head
cap screw heads do not project beyond the auxiliary
fence. Countersink holes in fence to install screws
properly.
⁄ " tall wood piece.
1
2
#8 x 2"
Wood Screw
⁄ "
3
4
Figure.72. Resaw barrier.
Qty
Figure.73. Example of auxiliary fence
attached to Model W1888 fence face.
-51-
⁄ "
3
4
Assembled
Resaw Barrier
Assembled Auxiliary Fence