Table of Contents
Advertisement
WXR720/L, WXR740/L
Trailer Wood Splitter
Fig. 13 – Hydraulic Tank Oil Level Dipstick
IMPORTANT! Do not operate machine if oil level
is not visible on the dipstick. Damage to the pump
and other components can occur.
Do not overfill the tank past the full mark.
IMPORTANT! Always check oil levels
after changing filters or servicing hydraulic
components.
IMPORTANT! Hydraulic oil quality should be
inspected every 50 hours. If the oil is dirty or
smells burnt, it should be replaced.
IMPORTANT! Be aware of high oil temperatures.
Temperatures higher than 180 °F (82 °C) could
cause seal damage and degrade oil quality.
6.6.1
The hydraulic system uses Dexron® III ATF.
1. Clean the area around filler cap and remove it.
2. Use a clean funnel and add oil until the level is at
the full mark on the dipstick.
3. Install filler cap securely. Wipe up any spilled oil.
6.7
Fuel Level Check
Check the fuel level daily.
Starting with a full tank helps to eliminate or reduce
operating interruptions for refueling.
The fuel tank is located on the engine. Avoid running
the tank dry.
00617
6.7.1
Fuel tank capacity: 0.82 US gal (3.1 L).
Refuel in a well-ventilated area with the engine
stopped. If the engine has been running, allow it to cool
first. Never refuel the engine inside a building where
gasoline fumes can come in contact with flames or
sparks.
For fuel specification, see Fluids and Lubricants on
page 32 . Refer to the engine manual for additional
information on fuels.
1. Clean the area around fuel tank cap. Fill the tank to
1/2" (12 mm) below bottom of filler neck to provide
space for any fuel expansion. Do not overfill.
25
Operating Instructions
Adding Hydraulic Oil to the Tank
Fig. 14 – Fuel Filler Cap
Refueling
WARNING!
Fuel vapors can explode causing
injury or death. Do not smoke while
refueling. Keep sparks, fl ames, and hot
components away.
00198
W027
Advertisement
Table of Contents
