Table of Contents
Advertisement
WXR720/L, WXR740/L
Trailer Wood Splitter
6.15 Transporting
6.15.1 Prepare for Transport
• On WXR740 Series splitters, make sure the
pivoting main frame is fully lowered to horizontal.
The lock pin in the pivoting splitter beam must be
fully engaged.
Fig. 27 – Lock Pin Fully Engaged on WXR740 Series
• Turn the fuel OFF when transporting.
Fig. 28 – Fuel Valve OFF
• Clean all debris from the splitter that could fall off in
transport.
• Check tire pressure. Inspect for cuts or damaged
rims.
• Check lug nuts and re-torque as necessary.
Inspect again after 20–25 mi (32–40 km). Check
weekly. See page 40.
• Inspect and replace any axle dust caps that are
missing, damaged or leaking.
• Always be in compliance with all applicable local
regulations when transporting.
6.15.2 Connecting a Tow Vehicle
1. Keep bystanders are clear of the machine.
2. Make sure there is enough room and clearance to
safely back up to the machine.
3. Slowly back the tow vehicle until the coupler on the
hitch and ball are aligned.
00624
WXR720 Models
4. Lift the hitch and place the coupler over the ball on
the hitch.
5. Flip the latch to lock the coupler around the ball.
6. Pull out the jack stand snap lock pin and raise the
jack stand to its stowed position. Install snap lock
pin to secure it.
WXR740 Models
7. Raise the rear jack stand and secure with the snap
00278
lock pin.
All Models
8. Cross safety chains under trailer tongue and attach
securely to the tow vehicle hitch.
9. Connect the wiring harness for the lights (as
equipped).
10. Reverse the above procedure when unhooking.
31
Operating Instructions
Fig. 29 – Ball Hitch Aligned
00207
Advertisement
Table of Contents
