Table of Contents
Advertisement
WXR720/L, WXR740/L
Trailer Wood Splitter
9. Troubleshooting
The following table lists some problems that may be
encountered, with possible causes and solutions.
If a problem persists after reading through the
Troubleshooting section, contact the local dealer,
distributor or Wallenstein Equipment. Have the
machine serial number ready.
Problem
Cylinder rod moves slowly or
does not move. Screeching or
hissing noise.
Control handle does not go
to neutral after rod is fully
retracted.
Control handle goes to neutral
before rod is fully retracted.
Control handle does not go to
neutral when released.
Cylinder stops on contact with
wood.
Wedge or push block jumps.
Leaking hydraulic hose.
Leaking cylinder.
Engine related issues
Refer to the Honda™ GX200 owner's manual found in
the manual tube.
Cause
No hydraulic oil pressure.
Wood jammed around wedge.
Low engine speed.
Valve detent set too tight.
Hydraulic oil too cold.
Hydraulic fluid is contaminated.
Detent set too loose.
Control may be damaged.
Second stage on pump not
functioning.
Wedge or push block frame
jamming.
Hose worn or damaged.
Seals worn.
37
Troubleshooting
Solution
Oil filter plugged. Change filter.
Low hydraulic oil level. Add oil.
System relief pressure setting too low.
Call technician.
Shut machine off and safely remove
wood.
Check throttle is set to maximum.
Check that choke is off.
Adjustment required to detent on
valve.
Allow machine to warm up.
Change hydraulic fluid and filter.
Adjustment required to detent on
valve.
Control may need service or be
replaced. Call technician.
Pump may need to be serviced or
replaced. Call technician.
Lubricate slider wear plates.
Replace hose.
Seal replacement may be required.
Call technician.
Advertisement
Table of Contents
