KidKraft HIGHLINE RETREAT Installation And Operating Instructions Manual page 16

Step 2: Back Wall Assembly
Note: It is important to note hole orientation for the following step.
A: Place (021) Lower Front Back so that one end is over (023) Upright Long and the other end is over (022)
Upright Short. Attach each end using 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer and t-nut) and 1
(S20) #8 x 1-3/8" Wood Screw making sure to note hole orientation. (fig. 2.1 and fig. 2.3)
B: Place (024) Floor Support Long so that one end is under the middle holes on (023) Upright Long and the other
end is under the end of (022) Upright Short. Attach each end using 1 (H3) 1/4 x 2- 1/2" Hex Bolt (with lock washer, flat
washer and t-nut). Check to make sure that assembly is square. (fig. 2.1 and fig. 2.2)
Fig. 2.1
1/4" Lock
Washer
1/4" Flat
Washer
023
Fig. 2.2
1/4" Lock
Washer
1/4" Flat
Washer
024
Wood Parts
1 x Lower Front Back 5/8 x 4-1/2 x 76-7/8"
021
1 x Upright Short 1-1/4 x 3 x 38"
022
1 x Upright Long 1-1/4 x 3 x 61"
023
1 x Floor Support Long 1-1/4 x 3 x 74-3/8"
024
H2
1/4" Lock
Washer
1/4" Flat
Washer
1/4" T-Nut
1/4" T-Nut
H3
022
1/4" T-Nut
S20
021
Note hole
orientation
H3
024
Fig. 2.3
021
022
Hardware
2 x 1/4 x 2" Hex Bolts
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x #8 x 1-3/8" Wood Screw
S20
2 x 1/4 x 2-1/2" Hex Bolt
H3
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
16
022
1/4" T-Nut
1/4" Lock
Washer
H2
1/4" Flat
Washer
1/4" T-Nut
H2
S20
S20