Advertisement
Step 7: Playhouse Assembly
Part 6
H: Taking note of hole orientation, place 1 (074) Upright Center against the end of (073) Center Tie, making sure
that its flush with the edge of (071) Panel Assembly. The bottom of the board should be on the inside of (021)
Lower Front Back. Attach the upper section of (074) Upright Center to the assembly using 6 (S20) #8 x 1 -3/8"
Wood Screws. (fig. 7.10)
I: Place 1 (075) Upright Block so that it sits flush between (021) Lower Front Back and (074) Upright Center.
From the outside install 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer and t-nut) and from the inside
install 2 (S20) #8 x 1 -3/8" Wood Screws. (fig. 7.10 and fig. 7.11)
J: Repeat Steps H and I to install (074) Upright Center on the Back Wall.
Fig. 7.10
071
Flush
073
074
S20
Wood Parts
2 x
Upright Center 5/8 x 3 x 61"
074
2 x
Upright Block 5/8 x 3 x 4-1/2"
075
S20
024
075
021
H2
Fig. 7.11
S20
1/4" T-Nut
S20
Repeat Steps H and I to install (074)
Upright Center on the Back Wall.
Hardware
16 x
#8 x 1-3/8" Wood Screw
S20
2 x
1/4 x 2" Hex Bolts
H2
(with flat washer, lock washer and t-nut)
28
Inside View
074
075
1/4" Lock
1/4" Flat
Washer
Washer
Flush
021
H2
Advertisement
