Advertisement
Step 3: Front Wall Assembly
Note: It is important to note hole orientation for the following step.
A: Refer to Step 2 but placing (023) Upright Long and (022) Upright Short on the opposite ends of the (021)
Lower Front Back. Attach each end using 1 (H2) 1/4 x 2" Hex Bolt (with lock washer, flat washer and t-nut) and 1
(S20) #8 x 1-3/8" Wood Screw making sure to note hole orientation. (fig. 3.1 and fig. 3.2)
B: Place (024) Floor Support Long so that one end is under the middle holes on (023) Upright Long and the other
end is under the end of (022) Upright Short. Attach each end using 1 (H3) 1/4 x 2- 1/2" Hex Bolt (with lock washer, flat
washer and t-nut). Check to make sure that assembly is square. (fig. 3.1 and fig. 3.3)
Fig. 3.1
H2
S20
1/4" T-Nut
Fig. 3.2
H2
S20
1/4" T-Nut
Wood Parts
1 x
Lower Front Back 5/8 x 4-1/2 x 76-7/8"
021
1 x
Upright Short 1-1/4 x 3 x 38"
022
1 x
Upright Long 1-1/4 x 3 x 61"
023
1 x
Floor Support Long 1-1/4 x 3 x 74-3/8"
024
021
022
1/4" Lock Washer
1/4" Flat Washer
021
022
S20
1/4" T-Nut
Note hole
orientation
H3
024
Fig. 3.3
022
Hardware
2 x
1/4 x 2" Hex Bolts
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
2 x
#8 x 1-3/8" Wood Screw
S20
2 x
1/4 x 2-1/2" Hex Bolt
H3
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
17
H2
1/4" Lock Washer
1/4" Flat Washer
1/4" Lock Washer
1/4" Flat Washer
1/4" T-Nut
023
H3
1/4" Lock Washer
1/4" Flat Washer
1/4" T-Nut
024
Advertisement
