Advertisement
Step 7: Playhouse Assembly
Part 1
A: With a helper lift (071) Panel Assembly up onto the righthand side of the playhouse floor and place it upright
with the open end at the front. (fig. 7.1)
B: On the inside of (023) Upright Long, place 1 (072) Side Barrier Top so that it's tight to (043) SL Barrier and all boards
are flush at the top. The other end should be tight to the (071) Panel Assembly (fig. 7.1). Attach (072) Side Barrier to
(023) Upright from the outside using 1 (H3) 1/4 x 2 -1/2" Hex Bolt (with lock washer, flat washer and t-nut) and to (043)
SL Barrier Top with 1 (S3) #8 x 2 – ½" Wood Screw (fig. 7.1 and fig. 7.2). Check that (072) Side Barrier is level then
attach other end to (071) Panel Assembly from the inside using 2 (S3) #8 x 2 – 1/2" Wood Screws. (fig. 7.1, fig. 7.3 and
fig. 7.4)
C: Repeat Step B to install a second (072) Barrier Top on the Back Wall. (fig. 7.1, fig. 7.2, fig. 7.3 and fig. 7.4)
Make sure the 072 side
Fig. 7.1
barrier top is level
Flush
023
043
Flush
023
Fig. 7.3
072
Flush
Wood Parts
1 x
Panel Assembly 8 x 22 x 43"
071
2 x
Side Barrier Top 1-1/4 x 3 x 32-7/8"
072
072
Flush
S3
071
071
1/4" Flat
Washer
1/4" Lock
Washer
Fig. 7.4
072
Hardware
2 x
1/4 x 2-1/2" Hex Bolts
H3
(with flat washer, lock washer and t-nut)
6 x
#8 x 2-1/2" Wood Screw
S3
23
Fig. 7.2
043
S3
Flush
072
H3
023
071
1/4" T-Nut
x 2
S3
Advertisement
