Ehsi Displays And Annunciators In The Full Compass Or Arc Modes - Honeywell SPZ-8000 Pilot's Manual

SPZ--8000 Digital Integrated Flight Control System
WX AND MAP/WX MODES ONLY
WX range
D
WX mode annunciator
D
WX return display
D
MAP AND MAP/WX MODES ONLY
Waypoints and track lines
D
VOR, DME, and VOR/DME symbols
D
Cross--track distance
D
TCAS traffic display (optional)
D
EHSI Displays and Annunciators in the FULL
Compass or ARC Modes
The locations of the EHSI annunciators and displays are shown in
Figure 4--30.
Wind Vector Display -- Wind information is displayed in
D
single vector that shows the direction of the wind relative to the
aircraft symbol. The wind velocity is displayed in a digital readout
next to the wind vector.
NOTE: When LASERTRAK
not displayed.
Heading Select Bug and Display -- Heading is selected and the
D
bug is positioned on the rotating heading dial using the HDG knob
on the instrument remote controller. The
heading dial. The difference between the bug and the lubber line is
the heading error sent to the flight guidance computer. A digital
heading select readout is used to accurately set the bug.
Pushing the PUSH SYNC button on the HDG knob synchronizes the
heading bug to the present heading. For the ARC mode only, if the
heading bug is off the scale, the off--scale arrow (above the compass
card boundary) shows the shortest direction to the bug.
Fore and Aft Lubber Lines -- The fore and aft lubber lines
D
represent the nose and tail of the aircraft relative to the rotating
heading dial.
Electronic Flight Instrument System (EFIS)
4-38
r is selected for display, wind data is
cyan
cyan as a
bug rotates with the
A28--1146--055
REV 2