Installation
3.2 Installation of the PC in the control cabinet
The C5102 Industrial PC has been designed as a rack mount PC for fitting into 19-inch racks used in
machine and plant engineering applications.
The ambient conditions specified for operation must be observed (see chapter
3.2.1 Preparation of the control cabinet
Four holes for the fixing bolts have to be provided in the control cabinet according to the dimensions of
the PC (see chapter
Assembly
Circulation of air
When the unit is installed in an enclosure, adequate space for ventilation and for
opening the PC must be provided.
Note
The clearance above and below the housing must be at least 5 cm in order to ensure
adequate ventilation of the PC.
Avoid extreme environmental conditions
Extreme environmental conditions should be avoided as far as possible. Protect the PC
from dust, moisture and heat.
Attention
The ventilation slots of the PC must not be covered.
14
dimensions).
Technical
Data).
C5102