January 2007
Replacing the fuse (AC system only)
The fuse is located below the power input socket on the rear panel. When
the server fuse blows, the server stops operating.
.
Requirements
You require the following:
an approved fuse for replacement
Two different types of fuses exist: one for North America, and one
for international use. Ensure that the fuse you are replacing has been
approved by Nortel for your region.
a flat-blade screwdriver
To replace the fuse
1
Power off the server.
2
Unplug the power cable from the wall outlet.
3
Unplug the power cable from the power input socket on the server.
4
Unscrew the fuse receptacle (see A in Figure 23 on page 130).
1002rp Server Maintenance and Diagnostics
CAUTION
Risk of equipment damage and personal injury
Disconnect power from the server before replacing a fuse.
Replacing basic chassis components
129