Before Installing This Product - SGM Q Series User Manual

Before installing this product

Please visit the SGM official website at sgmlight.com for the latest version of this user manual / safety information leaflet. Due to
continuous improvements, the instructions may change without notice. SGM always recommends the latest available firmware
version from sgmlight.com.
External cleaning and visual inspection of the fixture
All users of SGM luminaires should regularly clean the parts of the luminaire (the external housing and front lenses) directly
exposed to the elements. Additionally, all owners of SGM luminaires must periodically check the external housing of the
luminaire for structural breaks, components in bad shape, cracked lenses, or loose screws. To ensure proper operation, but
also to prevent the risk of potential accidents, do not use the luminaire if the lens, housing, or power cables are damaged. If
parts of the luminaire appear to be missing, cease use immediately and contact SGM support.
Wiring and conduit / containment
SGM luminaires supplied with power and data cable leads are not intended for installation in permanently installed conduit
or containment. When installing luminaires in a permanent installation, ensure that cable leads are installed as a service loop
to an appropriately rated junction box, using suitable cable strain reliefs / glands. All installed luminaires must be securely
mounted and service loop appropriately protected for installation location. All electrical wiring and connections should be
completed by a qualified electrician.
Safety Precautions
When using electrical equipment, basic safety precautions should always be followed including the following:
1. Do not mount near gas or electric heaters.
2. Permanently installed equipment should be mounted in locations and at heights where it will not readily be subjected
to tampering by unauthorized personnel.
3. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
4. Do not use this equipment for other than intended use.
5. Refer service to qualified personnel or authorized service centers.
6. Do not look directly into the beam for long periods of time, when the fixture is on.
7. The luminaire shall, under no circumstance, be covered with insulating material of any kind.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
5