Poi Spanner; Poi Tilt Lock; Installation And Rigging The Q-10 Poi; Connecting Dmx And Ac Power In Poi - SGM Q Series User Manual

POI Spanner

The Q-10 POI includes a spanner with a magnet, that serves the function of
establishing connection between the fixture and the wireless transmitter.
The spanner also has two types of pig-nose keys used for tilt adjustment in
POI fixtures. Depending on the type of fixture, either use the large or the small
pig-nose keys.
In Q-10 POI devices, the smallest pig-nose key is used for tilt adjustment.

POI Tilt lock

The tilt angle in POI fixtures may be adjusted by using the small pig-nose key provided in the spanner.
To adjust the tilt angle in Q-10 POI take the following steps:
1. Make sure the fixture has cooled down before handling.
2. Take the spanner and turn both tilt lock knobs (one on each side) counter-clockwise by using
the small pig-nose key. Screws are loosened by turning counter-clockwise.
3. Tilt the fixture to the desired angle and hold it.
4. Lock the position by tightening the tilt lock knobs clockwise with the same pig-nose key.
Installation and rigging of the Q-10 POI
While the base of the standard products includes 1/4 turn fasteners camlocks for omega brackets, the base of POI products comes
with M-10 nuts for M-10 screws. The M-10 screws are included in the package in the same amount as the number of M-10 nuts in
the base.
The Q-10 POI base has six M-10 nuts that can be used for installation and rigging. The SGM Omega bracket (not included) or a
customized bracket is needed to install the fixture. Consider the dimensions below of the Q-10 POI base for customized mounting
bracket purposes.
The SGM POI Omega bracket suited for M-10 holes can be ordered as an accessory. Contact your local SGM dealer for further
information on correct POI-rated mounting.

Connecting DMX and AC power in POI

DMX in and DMX out are in the same cable. See more in figure 20 about the SGM POI DMX cable.
Power is wired the same as the standard version. See "Connecting DMX and AC power in POI" on page 17.
For permanent installations, have a qualified electrician wire the mains cable directly to a suitable branch circuit. The junction's
ingress protection (IP) rating must be suitable for the location.
For a temporary installation, the mains cable may be fitted with a grounded connector intended for exterior use.
PLEASE NOTE!!
• Standard microphone cable is not suitable for transmitting DMX.
• Up to 32 fixtures can be linked to the same DMX link. Additional fixtures will overload the link.
• The last fixture must always be fitted with a DMX termination plug to the fixture's DMX out.
• SGM fixtures provide a passive DMX Thru signal as DMX Out, instead of an active output signal.
Figure 19: Q-10 POI base with dimensions
B
A
C
Figure 17: POI Spanner
Figure 18: Q-10 POI Tilt lock
A: Magnet
B: Small pig-nose key
C: Large pig-nose key
17