Advantech UNO-3072 User Manual page 24

Table 2.2: IRQ Setting via Switch 1 at SW3
Switch 1 at SW3 setting
Note: Please Refer to Figure A.3 for location of SW3
Note: After changing the jumper, please also adjust the IRQ
through the device manager software for the new set-
tings to work properly. (Refer to UNO Serial Port Instal-
lation Guide in the CD, steps 7 ~ 10)
Table 2.3: Transmission Rate (Switch 2 at SW3)
Switch 2 at SW3 setting
Y ou can adjust the transmission rate by the second switch of SW3.
* To increase the normal baud rates by eight times, (e.g. if we set the baud
rate as 115.2K bps in software, then the actual hardware baud rate will be
increased to 921.6K bps), set switch 2 of SW3 to "on".
Note: Only COM3 and COM4 can adjust the transmission rate.
UNO-3072 User Manual
O
1
N
2
O
1
N
2
O
1
N
2
O
1
N
2
Function
Share IRQ (default)
Independent IRQ
Function
Speed x 8*
Speed x 1 (default)
16