Pdu Installation - ATEN KN1108VA User Manual

KN1108VN / KN1116VN User Manual

PDU Installation

ATEN PDU products are intelligent Power Distribution Units that offer outlet
level control combined with remote access to give IT administrators the ability
to power control devices attached to the unit from practically any location via
a TCP/IP connection.
Note: The PDU GUI shown in the example is the PE9216r. Go to http://
www.aten.com/global/en/products/energy-intelligence-rack-pdu/kvm-
pdu/ for a list of supported ATEN PDUs.
To set up a PDU in conjunction with a KVM over IP Switch, refer to the images
below and do the following:
1. Connect both the KVM over IP Switch and the PDU to your Ethernet
switch.
2. In the PDU's GUI, browse to Device Management, then to OOBC. In
Console Port Settings, set the Baud Rate to 38400 bps.
3. Still in Device Management, browse to ANMS. In CC Management,
uncheck Enable.
29