Table of Contents
Advertisement
No.
Component
1
Power Sockets
2
Power
Switches
3
PON Port
4
Secondary
Serial Port
5
Secondary LAN
Port
6
Grounding
Terminal
7
Modem Port
8
Primary Serial
Port
9
Primary LAN
Port
10
Local Console
Port(s)
11
KVM Ports
The power cables plug in here.
This standard slide switch powers the unit on and off.
This connector is provided for a Power over the Net™
(PON) unit which allows servers attached to the KVM Over
IP switch to be booted remotely over the net. See Single
Stage Installation, page 19, step 6 for installation details.
Contact your dealer for more information regarding PON
units.
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
The cable that connects the unit to the backup network
interface (10/100/1000 Mbps) plugs in here.
The wire used to ground the unit connects here.
For dial in connection should the unit be unavailable over
the network. See Single Stage Installation, page 19, step 7
for installation details.
This port is provided to connect to legacy serial devices via
an SA0142 adapter.
The cable that connects the unit to the primary network
interface (10/100/1000 Mbps) plugs in here.
The unit can be accessed via a local console as well as over
the Net. The local console devices (keyboard, monitor and
mouse), plug in here. Any combination of USB and PS/2
keyboards and mice can be used.
The Cat 5e cables that link the unit to the KVM Adapter
Cables (which connect to the servers), plug in here.
Chapter 1. Introduction
Description
12
Advertisement
Table of Contents
