Innovative Technology SMART Coin System User Manual page 18

Smart Coin System User Manual
A summary of the Status Indicator Flash Codes for the payout module are shown
here:
Led Colour Status
Green Flashing
1Hz
Red 1 Flash
Red 2 Flashes
Red 3 Flashes
Red 4 Flashes
Red 5 Flashes
Red 6 Flashes
Red 7 Flashes
Red 8 Flashes
Red 9 Flashes
Copyright © Innovative Technology Ltd 2015
Description
Enabled and ready to
dispense
Hopper disabled
Calibration Fault
No Encryption key set
Coin jammed
Fraud Attempt detected.
Legacy, no longer used.
(Hopper empty)
Memory checksum error
Hopper sensors not
initialised
Legacy, no longer used.
(Lid removed).
Page 17 of 28
Action
Host system to send
enables command.
Optical sensor
contaminated. Operator
to clean exit sensor light
pipe. If fault persists,
return to ITL for service.
Host system to negotiate
key.
Remove power,
manually empty coins
from bowl and check
hopper base for stuck
coins. Try manually
turning the disc.
Persistent jam may
require returning to ITL
for service.
Reset hopper. If this
persists it indicates a
problem with the top
pay-out flap, light guide
or exit sensor.
Re-download hopper
firmware. If this persists
return to ITL for service.
Return to ITL for
service.
GA02033