Install Bottom Cover Or Cast Iron Fret - Valor Retrofire RF24KBN Installation & Owner's Manual

QUALIFIED
INSTALLER

Install Bottom Cover or Cast Iron Fret

Bottom Cover Installation
Slide the top fl ange of the bottom cover into slots
located at the bottom corners of the window frame.
Side View
Rear View
Top
Bottom
36
Installation
DO NOT use
Top flange
this hole
Top
Front Rear
Bottom
(end plates longer
Bottom flange than front plate
at bottom)
(bends here)
Fret Installation
Fret Brackets Installation RA24FK
1. Screw 2 thumbscrews into each retainer tab.
2. Fit the retainer tabs to each leg (1 screw per side).
3. Fit the slotted holes in the fret brackets over the
thumbscrews, push fret brackets downwards and
tighten the screws.
Fit thumscrews
to retainer tab
Fit retainer tab
to leg
Slip fret brackets
over thumbscrews
and tighten screws
Cast Iron Fret Installation
1. Adjust the screw heads on the back of fret to
the thickness of the fret bracket.
2. Drop the fret into place while guiding the screw
heads into the slots in the bracket.
3. Clip the ash pan cover onto the fret.
Drop fret with
bolt into slotted
bracket (fret
adjusts up or
down to suit)