Repair; Original Parts And Lubricants; Replacing The Lighting; Setting The Front Light - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

9.2

Repair

Special expertise and tools are required for many
repairs. For this reason, repairs may only be
carried out at a specialist dealer. These include:
• Replacing tyres and rims
• Replacing rims, brake linings and brake discs
• Replacing and tensioning the chain.
9.2.1

Original parts and lubricants

The individual pedelec parts have been carefully
selected and matched to one other.
Only original parts and lubricants must be used for
maintenance and repair.
The constantly updated accessory approval and
parts lists are in Section 11, Documents and
Drawings.
 Follow the operating instructions for the new
components.
9.2.2

Replacing the lighting

 Only use components of the respective power
class for replacement.
9.2.3

Setting the front light

 The front light must be set so that its light beam
shines on the road 10 m in front of the pedelec.
MY22K01 - 32_1.0_26.08.2021
Troubleshooting, fault clearance and repair
9.2.4

Checking tyre clearance

The tyre needs to be checked each time a
suspension fork tyre is changed to another size.
1 Release pressure from the fork.
2 Press fork together fully.
3 Measure the gap between the top of the tyre
and the crown's lower surface. The gap must
not be less than 10 mm. If the tyre is too large,
the tyre will touch the crown's lower surface if
the fork is fully pressed together.
4 Release pressure on fork and pump it up again
if it is an air suspension fork.
5 Take into account the fact that the gap will be
smaller if there is a guard. Check again to
ensure that there is sufficient clearance for the
tyre.
246