Using The Push Assist System - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

6.18.6 Using the push assist system

CAUTION
!
Injury from pedals or wheels
The pedals and the drive wheel turn when the
push assist system is used. There is a risk of
injury if the pedelec wheels are not in contact with
the ground when the push assist system is used
(e.g. when carrying the pedelec up stairs or when
placing it on a bicycle rack).
 Only use the push assist mode when pushing
the pedelec.
 You must steer the pedelec securely with both
hands when using push assist.
 Allow for enough freedom of movement for the
pedals.
The push assist helps move the pedelec. The
speed is a maximum of 6 km/h in this case.

The level of assistance < O F F > must not be
selected.

The tractive power of the push assist and its
speed can be influenced by the selection of gear.
We recommend using first gear for cycling uphill
to protect the drive.
1
Figure 173: Position of the push assist buttons on the
control panel
MY22K01 - 32_1.0_26.08.2021
1 Press the push assist button briefly.
 The push assist is activated.
2 Press and hold the plus button within three
seconds.
 Push assist is activated.
3 Release the plus button on the control panel
element to switch off push assist. The push
assist system switches off automatically as
soon as the pedelec wheels are blocked or the
speed exceeds 6 km/h.
Operation
153