Adjusting The Rockshox Fork Coil Spring With Spacer For Pre-Tensioning - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

6.5.12.3 Adjusting the ROCKSHOX fork coil spring with spacer for pre-tensioning

Only applies to pedelecs with this equipment
1 Put on normal cycling clothing (including
baggage).
2 Ask someone to hold the pedelec.
3 Stand on the pedals. Allow the damper to
deflect three times. Sit or stand on the pedelec
in a normal riding position.
4 Ask your helper to push the O-ring downwards
until it reaches the top of the dust wiper seal.
Figure 125: Moving the O-ring on the suspension fork
5 Get off the pedelec without allowing it to
deflect.
6 Note distance between dust wiper and the
O-ring. This distance is the sag.
1
Figure 126: Sag (1)
MY22K01 - 32_1.0_26.08.2021
7 Check the sag.
Setting
Prohibited
High sensitivity
Low sensitivity
Prohibited
Table 50: Recommended sag
Figure 127: Mandatory sag range (green) and prohibited
sag range (red)
8 If the desired sag is not achieved, the spring
preload must be adjusted internally and/or the
coil spring replaced. Contact your specialist
dealer.
Operation
Sag
>30%
20–30%
10–20%
<10
116