On-Board Computer Errors; Lighting Does Not Work - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

Symptom Cause
There is an unusual
smell.
Fumes are emitted from
the battery.
Table 65: Error solution for battery
9.1.5

On-board computer errors

Symptom Cause
The battery charge level may be
insufficient.
Is the power switched on?
No data are shown on the
Is the battery charged?
on-board computer if you
press the on-off button
(battery).
Is the connector fitted to the power
cable correctly?
A component may be connected which
the system is unable to recognise.
The gear level is not
The gear level is only shown if the
shown on the on-board
electronic gear shift is used.
computer.
The product is designed in such a way
The settings menu that the The settings menu cannot be
cannot be opened while opened if the system detects that
you are pedalling. someone is riding the pedelec. This is
not a malfunction.
The lock function cannot It may be a firmware error.
be set up or switched off.
The connect account has ...
been deleted or
deactivated and the lock
function is still activated.
The time display is The on-board computer battery has
flashing "0:00". come to the end of its service life.
Table 66: On-board computer error solution
9.1.6

Lighting does not work

Symptom Cause
The basic settings in the electric drive
Front lamp or rear lamp
system have probably been configured
does not go on, even
incorrectly.
when the switch is
pressed.
The light is defective.
Table 67: Lighting error solution
MY22K01 - 32_1.0_26.08.2021
Troubleshooting, fault clearance and repair
Remedy
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
1 Remove from the battery immediately.
2 Contact the fire service immediately.
3 Observe all the warnings in Section 2 Safety.
Remedy
1 Charge the battery.
2 Switch on the power.
 Press the On-Off button (battery) to switch the power on.
If the battery is fitted to the pedelec and is being charged, it cannot
be switched on.
 Interrupt charging.
1 Check whether the connector is fitted to the power cable
correctly.
2 The drive system now provides no assistance.
 Contact your specialist dealer.
1 Check that the power cable connector has not been
disconnected.
2 If this is not the case, contact your specialist dealer.
1 Stop the pedelec.
2 Change settings when stationary only.
 Contact your specialist dealer.
 Contact your specialist dealer.
 Contact your specialist dealer.
Remedy
1 Take pedelec out of service immediately.
2 Contact your specialist dealer.
228