Servicing The Steering Headset; Servicing The Fork - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

8.5.6

Servicing the steering headset

1 Remove fork.
2 Clean steering headset. If it is very dirty, flush
the bearing with cleaning agents such as WD-
40 or Karamba.
3 Check steering headset for damage.
 If the steering headset is damaged, replace
steering headset as specified in the parts list.
4 Grease steering headset and bearing seat with
highly viscous, water-repellent grease (e.g.
Dura Ace special grease by SHIMANO).
5 Re-fit fork with steering headset as per fork
instructions.
MY22K01 - 32_1.0_26.08.2021
8.5.7

Servicing the fork

Only applies to pedelecs with this equipment
WARNING
!
Injury due to explosion
The air chamber is pressurised. If the air system
in a faulty suspension fork is maintained, it can
explode and cause serious injury.
 Wear safety goggles, protective gloves and
safety clothing when assembling or carrying
out maintenance on the bicycle.
 Release the air for the air chambers. Detach
all air insert fitments.
 Never service or dismantle a suspension fork
if it has not completely rebounded.
CAUTION
!
Hazard for the environment due to toxic
substances
The suspension fork contains toxic and
environmentally harmful oils and lubricants. Such
fluids will contaminate if they enter the sewers or
groundwater.
 Dispose of lubricants and oils left over after
repairs in an environmentally responsible way
in accordance with statutory regulations.
1 Remove fork.
2 Check fork for cracks, warping and damage to
the paintwork.
 If there are any cracks, warping or damage to
the paintwork, remove the pedelec from
service. New fork as specified in the parts list.
3 Clean inside and exterior.
4 Grease fork.
5 Install fork.
Maintenance
209