Using The Usb Port; Using The Riding Light - Kettler Quadriga Comp Belt Translation Of Original Operating Instructions

6.18.4 Using the USB port

Notice
A USB connection is not a waterproof plug
connection. Any moisture penetrating through the
USB port may trigger a short circuit in the on-
board computer.
 Never connect an external device when
cycling in the rain.
 Always close the protective flap on the USB
port when cycling in the rain.
Regularly check the position of the rubber cover
on the USB port and adjust it as necessary.
 Connected electrical loads may have an
adverse effect on the Pedelec range.
The USB port can be used to operate external
devices which can be connected using a standard
micro A/micro B USB 2.0 cable.

The on-board computer and a sufficiently
charged battery must be in place on pedelec to
use the USB port.
1 Open protective flap on the USB port on the
on-board computer.
2 Connect the external device USB port with the
USB port on the on-board computer using a
micro A–micro B USB charging cable.
3 Replace the protective flap after using the USB
port.
MY22K01 - 32_1.0_26.08.2021

6.18.5 Using the riding light

Figure 172: Position of riding light button

The drive system needs to be already switched
on to turn on the riding light.
 Press the riding light button.
 The front light and rear light are both switched
on (riding light symbol is displayed) and
switched off (riding light symbol is not
displayed) at the same time.
Operation
1
152