Rfid; Test; Id Read - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE

5.10 RFID

Contents of RFID menu
Menu item
<7>RFID

TEST

MODULE
RETRY
UHF SETTING
OTHER
CARRIER SENSE
5.10.1 TEST
RFID tag data related to the test is read.
Menu item
<7>RFID
TEST

ID READ

5.10.1.1 ID READ
The printer enters the read test mode, and a read test is performed each time the [ENTER] key is
pressed. When the data of a tag can be read, it is displayed on the LCD.
When the read test failed, the following message is displayed on the LCD.
Error message
MODULE TYPE ERROR
COUNTRY CONFIG ERROR
READ ERROR
Confirm Setting or
set other Tag.
NOT AVAILABLE
NO RESPONSE
READ TIMEOUT
Set a RF-Tag on Ant.
UNKNOWN ERROR
NOTE:
Only the tags selected for the RFID tag type can be read.
If the type of the tag to be read and one selected by the RFID tag type selection do not match, the read
test results in an error. Therefore, RFID tag type shall be selected before the read test is started.
Error description
RFID module type has been set to NONE or a
communication cannot be established.
Country code has not been set.
The type of the tag to be read and one selected by the
RFID tag type selection do not match.
Not supported.
No response from the tag
Timeout
Other errors
5-67
EM18-33031
5.10 RFID