Mult Write; Carrier Sense - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE

5.10.5.2 MULT WRITE

・ OFF
・ ON
NOTES:
1. Gen2-compatible Hibiki tag (HITACHI) has a function which reduces the time to write data on the RFID
chips. This is called "Multi-word write". Use of this function enables a speed-up of the data write
operation. However, this function is unique to the Hibiki tag, and not usable with the other Gen2-
compatible chips.
2. The following modules do not support this function.
▪ B-EX706-RFID-U4-R
▪ B-EX706-RFID-U4-EU/US/AU-R

5.10.6 CARRIER SENSE

The printer enters the carrier sense mode, and performs a carrier sense. Environmental radio wave of
each channel is picked up for about 30 times during 5 seconds.
The menu structure of CARRIER SENSE
Menu item
<7>RFID
CARRIER SENSE
Display example
Display
NOTES:
1. This function is supported only by the B-EX706-RFID-U4-R.
2. The left-most number indicates a channel number. The percentage means the availability of the channel,
which is determined by performing approx. 30 carrier senses. Thus, "100%" means that any other devices
do not use this channel.
3. The MAX column shows the value of the maximum radio wave picked up. The larger the value is, the
stronger radio wave source exists nearby.
4. The display can be scrolled up or down, from Channel 1 (1CH) to channel 9 (9CH), by using the [UP] or
[DOWN] key.
5. Pressing the [ENTER] key causes the printer to perform a carrier sense again. To exit a carrier sense,
press the [CANCEL] key.
6. When the RFID module type is set to "NONE" or a communication cannot be established, a message,
"NO RFID MODULE", is displayed.
7. When the RFID module type is set to other than U2, a message, "NOT AVAILABLE" is displayed.
8. When the RFID module type is set to U2 but effective data cannot be obtained, a message, "NO
RESPONSE" is displayed.
9. If the RFID module's country setting is not specified (user-inaccessible setting), an "RFID CONFIG ERR"
message is displayed.
5-78
EM18-33031
5.10 RFID