Toshiba B-EX6 Series Maintenance Manual page 67

4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
Antenna position: Center
Shielding plate: Not required
Antenna Shield
1. Remove the antenna shield as per Step 1 to
2 of Front Position (Antenna Shield Disable),
and remove 2 screws as shown.
Antenna position: Rear
Shielding plate: Not required
1. After the antenna shield and antenna screws
have been removed, detach the connector of
the PCB from the antenna.
3. Re- connect the black wire to the
antenna as shown in figure above.
Antenna
Screws
Connector
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
2. Move the antenna in the middle position and
observe proper alignment as shown in the
figure above. Attach the two screws back
with the new antenna position.
2. Reroute the black wire to the other side
as shown in the figure above.
4. Attach the antenna and secure with 2 screws,
the proper alignment shown in the figure
above.
4-50
(Revision Date: Mar. 1, 2017)
Screws
Black wire
Screws
EO18-33031