Power Save Time - Toshiba B-EX6 Series Maintenance Manual

5. SYSTEM MODE
7. If the second black mark/gap is not found under the above conditions, the printer continues media feed for up
to 500.0 mm to find the second black mark/gap. If it still cannot be detected, the printer will stop, as a paper
jam.
8. This function supports the media pitch of 10.0 mm to 150.0 mm.
9. When the cutter is installed and a previous issue mode was cut mode, the media is cut and ejected after an
automatic calibration completes.
10. While the automatic calibration is in operation, labels do not stop at the strip position even in strip or special
strip mode.
11. When a label end occurs during an automatic calibration, the printer stops, resulting in an error. Closing the
print head after loading a new label can clear the error and resume the automatic calibration.
12. During an automatic calibration, the ribbon motors are rotated. Even if the ribbon is not loaded, no ribbon
error occurs. However, the print condition will be automatically changed to "No ribbon" after the calibration
ends.
13. When "ON TRANS+BackFeed", "ON REFL+BackFeed" or "ON ALL+BackFeed" is selected and if the
following conditions are satisfied, the printer feeds the media backward for the media pitch length while lifting
the print head.
Hardware
Parameter setting
Operating condition
Remarks
14. The feed speed during the automatic calibration is 3 ips.
15. The print head must not be opened during automatic calibration as the subsequent printer operation is not
guaranteed. If the print head is opened, turn off the power and back to on.
16. During an automatic calibration, the ribbon save is not performed even if setting is enabled.

5.5.13 POWER SAVE TIME

Max.
Min. value
value
240 1
Optional ribbon saving module (solenoid) is installed.
RIBBON SAVE parameter is set to TAG or LABEL.
Media pitch falls between 20mm and 100mm.
The previous issue mode was Batch without cut. (The issue mode and the cut
interval are not reset by a power off or a printer reset.)
Even if the hardware requirement is not satisfied (i.e. the optional ribbon saving
module is not installed), the printer feeds the media backward when the other
requirements are satisfied. However, this operation is not guaranteed as it is
outside of the specification.
Step Display
1 Decimal
Integer Decimal
Sign
digit
None 3
5-32
5.5 SET PARAMETERS
0-padding
place measure
0 None
EM18-33031
Unit of
Min.